New Toy! This is an edge break tool from Cleaveland Tool company. It "breaks" the edge the large sheets of aluminum where they overlap another sheet of aluminum, preventing it from curling up.
Removed some material ffom the first sheet I'm sure that this was left to help support this sheet will being moved around, otherwise the sheet is so long, it could bend easy while flopping around.
Clecoed the shear clips to the J stiffeners The instructions on this were confusing. The ID numbers were reversed from one drawing to the other. The clips in the last illustration are correct.
Pop riveting done! This could have gone a lot faster if the plans were correct. I spent quite a bit of time researching which of the 2 drawing were incorrect.
