Smitty's RV-9A from Van's Aircraft

RV-9A: Project Entry

Share on:

Hooked up the Heater Control Cable
I had to special order a #10 drill bit for my pneumatic angle drill from Aircraft Spruce to drill a hole in the engine wall aluminum angle support, so the control cable could go through it. Then I used a small pair of needle nose pliers to make the bends in the end of the control cable for the arm of the heater box flap.

SmittysRV.com is an Amazon Associate

HOMEBUILT, EXPERIMENTAL AND KITBUILT INSURANCE

Rod Machado Free Pilot Training Course Syllabus