Smitty's RV-9A from Van's Aircraft

RV-9A: Project Entry

Share on:

Ready to start riveting the trailing edges
It took quite a while to get the first aileron loose from the table where I clecoed it to the work top. Some of the proseal leaked out around the clecos under the aileron, apparently glueing the aileron to the table. After I pulled out all the clecos, I laid a putty knife flat on the table under the aileron edge and ran it down the table under the trailing edge to free up the aileron. I was thinking that there must be a butt-load of proseal under there. After removing the aileron from the table I saw only a few small spots around the clecos where the aileron was glued to the table top. That proseal stuff is really strong!

SmittysRV.com is an Amazon Associate

HOMEBUILT, EXPERIMENTAL AND KITBUILT INSURANCE

Rod Machado Free Pilot Training Course Syllabus