Smitty's RV-9A from Van's Aircraft

RV-9A: Project Entry

Share on:

Finished riveting the Main Ribs to the Right HS skin
This wasn't near as hard riveting the front spar in place. The instructions said to not rivet the end ribs in place until the middle ribs were all riveted in, because they would make it hard to get to the middle ribs with the bucking bar. I didn't have any problem getting to any of the ribs. I used mine Avery hand rivet squeezer to finish off the outer ribs.

SmittysRV.com is an Amazon Associate

HOMEBUILT, EXPERIMENTAL AND KITBUILT INSURANCE

Rod Machado Free Pilot Training Course Syllabus