RV Aircraft Construction Website

RV-9A: Project Entry

Share on:
Share this! Twit this! 

Hey, why stop now?

I pulled out the right wing ribs and dusted off the cobwebs. The first thing that I needed to do was to drill the wiring holes in each rib. Rather than try to do figure out where each hole goes scientifically, I just grabbed a hunk of cardboard and made a template off one of the finished ribs in the left wing. After marking each rib, I used my spring punch to establish a small dent in the rib to keep the Unibit centered where the hole goes.

SmittysRV.com is an Amazon Associate
SmittysRV.com is an Amazon Associate
HOMEBUILT, EXPERIMENTAL AND KITBUILT INSURANCE
gopro camera mounts for aircraft
Aircraft fiberglass 101
Rod Machados NEW The Art of Takeoffs and Landings interactive eCourse
Rod Machado Free Pilot Training Course Syllabus
RV Metal Aircraft Tools
Rod Machado Pilot Training
Rod Machado Pilot Training