|
Share on:
|
|
|
Attached a 2x6 support under the cutouts
The plans show a slight cutout of the 2x6 to match the lower half of the plywood cutouts. I my opinion, making these thick cutouts on a 2x6 with an ordinary jig saw is just plain nuts. Instead, I just positioned the 2x6 to where the top edge of it was flush with the bottom of the plywood cutouts. I will go back later and put some short 1x2's on top of the edge of the 2x6 on each side of the cutouts, to insure the hold on the wing spar.
|
|
