|
Share on:
|
|
|
Drilled all the holes for the conduit
From reading the emails from the various groups, here is where most builders freak out, as did I. As not mentioned in the plans, there is an FAQ page on Van's website that details the options for running wires in the wings. After reading all about my options, I opted for the 3/4 inch hole in the lower front part of each rib. I used my Unibit to drill all of these holes. The corrigated plastic conduit that will go through these holes is a little over 12 bucks for a fifty foot roll. I started to order some, but the shopping cart item description on Vans parts ordering system stated that this conduit comes in the wiring kit for the aircraft. I'm not sure when the conduit should go in.
|
|
