|
Share on:
|
|
|
Cut out the T-911 and T-911-INBD stiffeners
Alrighty! This I know how to do! I drew the lines on the striffeners as indicated by the drawing and rough cut the stiffeners out with my band saw. Then I finished them off with the bench sander. The next step is to run them over the scotchbrite wheel to get the burrs off. One of the stiffeners is shorter than the rest. It is the inboard stiffener. I had visualize this one, because it appears that there is a definite "left" and "right" tank application here.
|
|
