|
Share on:
|
|
|
Started attaching the stiffeners
I used my 2 syringes to suck up 20 cc’s of the proseal white goo and 2 cc’s of the black goo. I pushed everything out of the syringes onto a paper plate and mixed it all together with a popsicle stick. I decided not to put the mix into the third syringe for applying the proseal to the stiffener. Just too messy. Instead I used a popsicle stick to put a 1/16” layer of proseal on the back of the stiffener. Then I pressed the stiffeners onto the skin, allowing some of the goo to ooze out around the edge of the stiffener. I also decided to only do one stiffener at time. Then I back-riveted the stiffener in place. This pushed even more goo out around the edges. Then I used my popsicle stick at an angle to smooth out the edges around the stiffeners, making sure the proseal had a good seal all the way around the stiffener, kind of like caulking a new piece of glass into a window. Then I went back and put small glob of proseal on top of each rivet. I found that 22 cc’s of proseal will do 3 stiffeners. Having to make 2 batches for this session actually worked out better for me because I noticed that the proseal was starting to setup after the third stiffener. The temperature in the garage was in the 90’s, which, I sure, had something to do with the proseal setting up faster. After attaching all of the stiffeners, I removed the blue painters tape.
|
|
