|
Share on:
|
|
|
Now to drill some holes into the side flange
I know that the GPS bracket is already at a perfect 90 degree angle to the bottom of panel, so I decided to just butt the EFIS mounting tray right up next to it. Then, after marking where the screw holes will go, I drilled the holes into the mount tray flange and also into the panel from the back of the panel, using a long #40 drill bit. Then I put clecos in on the front of the panel to hold the mounting tray in place. These #40 holes will get drilled out later to 7/64" for the 4-40 screws I will use.
|
|
