|
Share on:
|
|
|
Ready to start riveting the trailing edges
It took quite a while to get the first aileron loose from the table where I clecoed it to the work top. Some of the proseal leaked out around the clecos under the aileron, apparently glueing the aileron to the table. After I pulled out all the clecos, I laid a putty knife flat on the table under the aileron edge and ran it down the table under the trailing edge to free up the aileron. I was thinking that there must be a butt-load of proseal under there. After removing the aileron from the table I saw only a few small spots around the clecos where the aileron was glued to the table top. That proseal stuff is really strong!
|
|
